Halamid broad spectrum disinfectant

Halamid® broad spectrum disinfectant is a highly effective and versatile biosecurity disinfectant with a large activity spectrum. Once mixed, it will remain stable for several weeks*. It’s also non-corrosive on metal and very safe to use.

Halamid® 5kg broad spectrum disinfectant


  • Highly effective and versatile biosecurity disinfectant with large activity spectrum
  • Kills pathogens in 5-10 minutes
  • Non-corrosive in solution, safe for milking equipment
  • Good for all-shed situations and rearing pens
  • Footdip disinfectant
  • Stable formulation, readily biodegradable and safe to use
  • Nil risk of resistance
  • Use in combination with Stalosan® F for a total hygiene solution
  • Available in 100g, 2kg and 5kg

*Halamid (1-10%) solution will remain stable for weeks if kept out of direct sunlight. Stability is also dependent on pH,
which should remain above 7 to guarantee stability. A 1% solution of Halamid in demineralised water normally has a pH of 9.


Halamid® is effective against many known pathogens related to intensive farming applications. A few of them are indicated below, but the complete activity spectrum of Halamid® is much wider.




Salmonella sp Avian Influenza virus Aspergillus brasiliensis/niger
Campylobacter sp Adeno virus (egg drop syndrome) Aspergillus fumigatus
E-coli Newcastle disease
Listeria Gumboro disease (IBD)
Pseudonomas aeruginosa Infectious bronchitis virus (IBV)
Staphylococcus aureus Avian reovirus (viral arthritis)

General disinfection rules

Always remember that cleaning is a required preliminary step before disinfection, to ensure the best results. Without proper cleaning, dirt and organic matter protect microorganisms against the killing effect of the disinfectant, resulting in an incomplete operation.

Start by cleaning the area while dry, to remove most of the organic matter, followed by cleaning with water or a detergent solution. Then, disinfect with Halamid.

Halamid is always applied as an aqueous solution: simply dissolve the Halamid in clean water at the required concentration.

Application rates

Concentration of Halamid (to clean water)


Disinfection of rearing and housing barns 100g/10L Apply 0.3L per square metre (or 1L per 3m²)
Teat disinfection 30g/10L
Milking equipment disinfection 50g/10L Rinse with clean water
Footdip 200g/10L Renew as often as needed
Vehicle disinfection 100g/10L

NOTE: Use biocides safely. Always read the label and product information before use.

Use Halamid with Stalosan® F in your pre-season pen preparation. For more information about Halamid or to place an order, please contact us.

MSDS Information